Child Safety Window Guards

Installation Instructions

CHILD SAFETY WINDOW GUARD INSTALLATION INSTRUCTIONS
Model No. 1123, 1124 and 1125 Window Guards for windows 24" to 42" wide.
Model No. 1123-S Window Guards for windows 14-1/2" to 24-1/2" wide.
Model No. 1123-L Window Guards for windows 42" to 58" wide.

NYC APPROVALS
HDWG 05-87-86
HDWG-04-93-09

1.  Install only in solid, non-rotting window tracks.  Expand Guard to fit tightly into outside window track.

2.  Temporarily support Guard in level position NO MORE THAN 4-1/2 inches from sill to upper half of bottom bar.  Mark location of holes on each side.  Remove Guard and drill 5/32" dia. pilot holes 1" deep.

3.  Re-position Guard and mount with #10 one way screws (included.)

4.  Raise the inner window NO MORE THAN 4-1/2" above the lower half of the top bar.  Position "L" shaped stops so as to limit the opening above the Window Guard to a maximum of 4-1/2" (see illustration).  Mark and drill 5/32" dia. pilot holes 1" deep.  Mount stops with #10 one way screws (included).

NOTE:  FOR USE ON DOUBLE HUNG WINDOWS ONLY-SEE ILLUSTRATION



WARNING
Use of this guard beyond specified maximum width is dangerous and illegal.  Use of this gate on a fire escape window in New York City is illegal, a serious safety hazard and may result in a fine by the Department of Buildings.


         
11600 STERLING PARKWAY, BOX 469 RICHMOND, IL 60071-0469, U.S.A.
PHONE 815-678-2031 • 1-800-367-5726 • FAX 815-678-4360

E-mail: info@johnsterling.com
Copyright © 2000 John Sterling Corporation